Embedded industrial control host cannot start normally

Jun 03, 2021

메시지를 남겨주세요

1. After the embedded industrial computer is powered on, the power supply works normally, but the motherboard does not respond.


   First remove the peripheral plug-in cards and connected equipment to see if the industrial computer can be started; if not, remove the memory to see if it alarms; then check whether the CPU is working properly; finally, replace the motherboard and check whether the motherboard is normal.


   2. After the industrial computer is turned on, the motherboard has a self-check sound, but the monitor has no display


   1. Check whether the display is connected to the host normally


  2, insert another display card to see if it can display normally


  3. Clear CMOS or replace BIOS


   4. Replace the CPU board or display



(X86 industrial computer)


  3. The motherboard cannot successfully self-check after the industrial computer is turned on


   1. Press "Del" to reset CMOS or clear CMOS


  2, replace the memory bar


  3. Re-flash the BIOS or replace the same BIOS chip


  4. The memory self-test after the industrial computer is turned on does not match the actual capacity


   1. Check whether the motherboard's video memory is shared with the motherboard's memory, so that a part of it will be divided from the memory as the video memory


  2. Check whether the memory is small-particle memory, because some old chips do not support large-particle memory, only half of the capacity is displayed after plugging in


  3. There are very few motherboards that use special CPUs, occupying part of the memory as an instruction decoder for CPU instruction set conversion, which causes the memory capacity to be inconsistent


(Android embedded industrial computer)


  5. After the industrial computer is turned on, the motherboard self-check is successful but the system cannot be booted from the hard disk


   1. Press the "Del" key to enter the CMOS hard disk parameter settings and whether the boot sequence is correct


  2. After booting with a CD-ROM drive or a floppy drive, check whether the hard disk has a boot system or whether the hard disk is partitioned normally and the boot partition has been activated


  3, use FDISK/MBR command


문의 보내기